1. Eliminate the dust and dirt in the explosion-proof lamp shade regularly, improve the luminescent power and heat dissipation function of the lamp.

Method According to the luminaire used to maintain the enclosure, clean the water (the luminaire above the mark) or scrub with a damp cloth.

When the water jet is clean, the power supply should be blocked. Do not use a dry cloth to clean the plastic (transparent) shell of the bulb to prevent static electricity.

2. Observe that the cover of some bright spots has been affected by foreign bodies, and keep the network not loose, unwelded, corrosion and other phenomena.

If this is the case, please stop using and promptly repair.

3. The light damage should be turned off in time, and the notice of change should be informed in order to prevent the light source from starting and making the ballast electrical components abnormal for a long time.

4. The lamp cavity used is in a humid environment, such as water should be removed in time, and the sealing parts should be replaced to ensure maintenance.

5. When turning on the lampshade, it should be closed after opening the requested card.

6. After opening, it should be checked whether the appearance of explosion-proof joints is intact, whether the rubber seal is sticky, whether the wire insulation is green, carbonization, whether the insulation parts and electrical parts are deformed and the combustion fraction. If you have any doubts, please repair and replace it promptly.

7. Closed application of the front cover wet cloth quietly scrub the lamp (not too wet) backlight and bright light, in order to improve the luminescent power of the lamp.

8. Check whether the transparent parts are damaged by foreign bodies, and whether the maintenance net is loose, unwelded, or corroded. If yes, stop using it and repair it in time. Recommended reading: The merits of high quality explosion-proof electroless lamps

9. If the light source is damaged, turn off the bulb and inform the replacement of the bulb in time to prevent the ballast and other electrical components from being abnormal for a long time, because the light source cannot be started.