LED explosion-proof lamp 10 common sense

1. Regularly remove the dust and stains in the LED explosion-proof lampshade to improve the luminous output power and heat dissipation of the lighting fixture. The actual operation can be wiped clean with a clean cloth.

LED explosion-proof lamp

2. Observe the damage of some flash points that have already been damaged by dirt. The maintenance net is not loose, desoldered, etched, etc. If such a situation occurs, please stop and deal with it immediately.

3. The light should be turned off immediately, and the change should be notified to avoid the start of the light source, so that the electronic ballast components are in an abnormal state for a long time.

4. The lamp cavity of the application should be used in a wet and cold environment. If there is water inflow, it should be eliminated immediately, and the seals should be replaced to ensure normal operation in a humid and cold environment.

5. When opening the lamp cover, turn it off after opening the card requested by the post.

6. After opening, it should be checked whether the appearance of the explosion-proof connector is intact, whether the rubber seal is thick, whether the cable insulation is green, carbonized, whether the insulation components and electrical equipment components are deformed or aged. If it is found to be inconsistent with the standard, please repair and replace it immediately.

7. Closed use of the front cover to clean the backlight and light of the lighting fixture with clean cloth water to enhance the luminous output of the lighting fixture.

8. Check whether the fully transparent parts are damaged by dirt and whether the maintenance net is loose, desoldered or etched. If something goes wrong, please disable it and fix it now.

9. If the light source is destroyed, immediately cut off the power supply and replace the light bulb to avoid the electrical components such as electronic ballasts being abnormally loaded for a long time, resulting in the light source not starting.

LED explosion-proof lamp

10. When opening the Led explosion-proof lamp cover, the cover should be opened after the power is turned off according to the notice.