1. Please read the manual carefully before using the miner\'s lamp and operate it correctly as required.

2. The miner\'s lamp should be charged fully on the ground first, and then use it after checking normal.

3.The alarm miner\'s lamp should be calibrated regularly.

4. It is strictly forbidden to use lighter gas to test at the detection point of the lamp cap to prevent the high concentration gas from damaging the methane sensor.

5.The use and storage environment of the alarm miner\'s lamp are prohibited strictly from chemical substances such as sulfide and organic silicon.

6. Miner\'s lamp should avoid violent collision when carrying and using.

7. It is strictly prohibited to short-circuit and disassemble the two ends of the battery.

8. The miner\'s lamp should be repaired by professionals. It is strictly forbidden to change the specifications of the device during maintenance, and please use the accessories provided by our company.

9. Miner\'s lamps are prohibited strictly to be disassembled and repaired underground.

10. If the light source is damaged during use of the miner\'s lamp, and it should be repaired and replaced in time after going into the well.

11. The waste batteries should be disposed of properly. It is strictly forbidden to put the batteries into fire and heat them up.

12.The charger of the miner\'s lamp is a non-explosion-proof product, which is strictly forbidden to be used under the mine.

13.The miner\'s lamp should be stored and transported at 80% battery capacity, and it should be charged for a long-term storage of more than three months.