1. Affirm the installation status of lighting fixtures, choose appropriate installation methods,

And prepare the corresponding length of&phi according to the interval between the lamp and the 220V power supply contact; 6-8mm three core cable;

2. Pull open the two locks on the lamp holder and flip the back cover. Thread one end of the prepared three core cable through the inlet,

Connect the outpost (L) to&quo; L” On the terminal, the zero wire (N) is connected to" N” On the terminal, the ground wire (PE) is connected to&quo; PE” On the terminal,

After pressing the imported cable tightly with a compression nut, close the back cover and tighten the locking buckle,

Finally, connect the other end of the three core cable to the power supply to achieve lighting.

3. When converting the lamp holder, follow usage method 2 to open the back cover and turn the lamp holder to the right,

And quietly pull out the lamp cover, unscrew the old lamp holder from the lamp holder, and replace it with a new lamp holder.