Explosion-proof floodlights are suitable for hazardous areas in Zone 1 and Zone 2; suitable for IIA, IIB, IIC class T4 and below explosive gas environments; widely used in workshops, substations, coal plants, ports, oil well platforms and other places for large areas For flood lighting.

  installation method:

1. Wall-mounted installation: first connect the lamp body to another bracket through the wall or bracket, then connect the cable to the connector, washer and top ring to connect it to the junction box, then tighten the connector and tighten the set screw .

2. Vertical boom type installation: Pass the connector through the cable, screw it into the steel pipe, tighten the fixing screw, and then pass the cable through the gasket and sealing ring through the junction box (reserve a certain length of cable for wiring). Tighten the lamp body, connector and tighten the screws.

3. Ceiling installation: screw the 3/4 pair of adapters into the pendant type adapter, screw the joint into the 3/4 inch adapter, tighten the set screws respectively, and then pass through the cable, install it on the roof, and then install it on the roof. Pass the cable through the gasket and seal it until it is in the junction box (reserve a certain length of cable for wiring), then tighten the lamp body and the dial head, and tighten the set screw.