Industrial and mining lamps are lamps used in production homework areas in factories and mines. In addition to various lighting lamps used in normal environments, high bay lamps also include explosion-proof lamps and anti-corrosion lamps used in special environments. There is still a lot of knowledge about high bay lights, the following Yangzhong Hengyuan Lighting introduces the installation steps and installation precautions of high bay lights.

Step forward: In the position where the high bay light needs to be installed, the hook is pre-installed (the hook can be used with the ring, and the load capacity must exceed 30Kg when installing the hook)

Step 2: Clip the hoisting ring on the lamp into the previously installed hook, so as to hoist the lamp through the hoisting ring;

Step 3: Connect the power cord from the site to the power cord of the lamp, and connect it in accordance with the principles of "Brown----L", "Blue----N" and "Yellow wire to ground", and do a good job at the same time Waterproof and insulation treatment;

Step 4: Turn on the power and confirm whether the high bay light can work normally;

Step 5: After confirming that the light is on, follow the instructions.

Precautions for the installation of high bay lights

1. When installing high bay lights or replacing accessories, be sure to disconnect the power first;

2. When connecting the power supply, pay attention to the adaption of the input voltage and the industrial and mining lamp. After the power cord is connected, the relevant waterproof and insulation treatment must be done.