LED explosion-proof lamp installation technology is a knowledge, which directly affects the overall performance of explosion-proof lamp.

Directly from the lamp wiring down the best use of pipe wiring channel outdoor distance access to the main line,

If there is a Central Line to use explosion-proof junction box, if there is a master switch to use explosion-proof.

LED explosion-proof lamp device connection and use method;

1, affirm the device status of lamps and lanterns, choose the appropriate device method,

And according to the interval between the lamp and the 220V power supply contact point, prepare the corresponding length φ 6~8mm three-core cable;

2. Pull open the two locks on the lamp holder to open the back cover, and pass one end of the prepared three-core cable through the introduction port.

Then press the cable at the inlet with the clamping nut, close the back cover, and fasten the locking buckle.

Finally, the other end of the three-core cable is connected to the power supply, and lighting can be realized.

3, change the lamp bile, according to the method of use 2 open the back cover, turn the lamp holder right,

And pull out quietly from the lamp cover, unscrew the old lamp bile on the lamp holder, and replace the new lamp bile.