1. Over the position of the device of the lamp, choose the appropriate device method,

And press the lamp to the interval from the 220V power supply to prepare the φ6 ~ 8mm three -core cable that echo the length;

2. Open the two locks on the lamp holder to open the rear cover to pass the prepared three -core cable across one end through the introduction.

Connect the outpost (L) on the "L" terminal, the zero line (n) is connected to the "n" terminal, the ground (PE) is connected to the "PE" terminal,

Then press the cable that introduces the introduction of the mouth tightly with a compact nut, close the back cover, and the lock is tightly lock.

Finally, the power supply can be connected to the other end of the three -core cable to achieve lighting.

3. When converting the lamp bile, turn on the rear cover 2 according to how to use it.

And quietly pull out from the lamp cover, spin the old lamp on the lamp holder, and put on the new lamp bile.