To the front, the distribution of lamps. Reasonably design the installation position of the lamps and lanterns, so that the light source should be reasonably distributed, and no dark areas should appear. The distribution of lamps and lanterns can make people feel that the space is large, bright, without fatigue, and the working environment is comfortable. The construction area should carry out reasonable distribution and selection of LED high bay lights.

    Second, when installing and using Zhenjiang hanging LED high bay lights, you should pay attention not to press some wires wrongly, because the internal chip or the design of some shells including some lamps are all in accordance with the steps. With the intervention of some wires, it is mainly to be able to perform some related modulations when using it, so that a better use effect can be achieved.

    Third, when installing Zhenjiang hanging LED high bay lights, you must first pay attention to electricians must have a certificate to work, so as to avoid damage to this lamp, before installation, you must also check whether the entire lamp has a certain integrity, yes It cannot be installed normally, and it is not possible to lack a part. Try to keep a certain installation distance from flammable materials, otherwise there will be some explosions or effects that cannot be used normally.

    Fourth, after the installation is completed, the site should be checked to see if there are any blind spots in the lighting. It should be ensured that the lighting of the lamps meets the requirements.

    Fifth, when installing the Zhenjiang hanging LED high bay light, handle it with care, and don't drop it randomly and cause damage to the light. Strictly follow the installation instructions required by the manufacturer.

According to the bright function, it can be divided into general lighting and local lighting.

General lighting

General lighting lamps are usually arranged evenly on the upper side or side walls of the work site. To illuminate the entire work surface, it is necessary to use high-power incandescent lamps, tungsten halogen lamps, high-intensity gas discharge lamps or a large number of fluorescent lamps. Of course, there are More energy-saving high-power LED industrial and mining lamps, etc., most of the industrial and mining lamps belong to this category. General lighting lamps have higher requirements for light distribution, and two types of light distribution, direct lighting and semi-direct lighting, are widely used, especially the latter. In the semi-direct lighting type, the upward light from a department illuminates the ceiling, which can increase the brightness of the ceiling and create a more comfortable and brighter environment.

Local lighting

Local lighting is a kind of lamps that improve the illuminance of a certain working part. Its function can be to strengthen and supplement the lighting on the basis of general lighting, or it can be used as temporary lighting in some places that do not need lighting at ordinary times (such as equipment inspection and maintenance places). Most of their light distribution is not strictly defined. Local lighting is usually installed around the work area, using incandescent lamps and tungsten halogen lamps with safety extra-low voltage (≤50V, AC effective value) as the light source. There are (hand-held) running lights, hanging lights, work desk lights, machine tool work lights, etc. In some tall factories, spotlights are sometimes used for local lighting.