To the front, the distribution of lamps. Reasonably design the installation position of the lamps and lanterns, so that the light source should be reasonably distributed, and no dark areas should appear. The distribution of lamps and lanterns can make people feel that the space is large, bright, without fatigue, and the working environment is comfortable. The construction area should carry out reasonable distribution and selection of LED high bay lights.

Second, when installing and using LED high bay lights, you should pay attention not to press some wires wrongly, because the internal chip or the design of some shells including some lamp tubes are all according to the steps, plus some The intervention of the wire, so when using, it is mainly to be able to perform some related modulations well, so that a better use effect can be achieved.

Third, when installing LED high bay lights, you must first pay attention to electricians must be certified to work, so as to avoid damage to this lamp, before installation, you must also check whether the entire lamp has a certain integrity, whether it can be normal It’s impossible to install without a part. Try to keep a certain installation distance from flammable materials, otherwise there will be some explosions or effects that cannot be used normally.

Fourth, after the installation is completed, the site must be checked to see if there are any blind spots in the lighting, and it should be ensured that the lighting meets the requirements.

Fifth, when installing the LED high bay light, handle it with care, and don't drop it randomly and cause damage to the light. Strictly follow the installation instructions required by the manufacturer.

Six characteristics of LED high bay lights

1. Environmental protection and energy saving: normal life of lamps and lanterns; more than 30,000 hours.

2. Under the front embankment of equal brightness, the 70W LED high bay light can save 60% of electricity compared to the 175W high pressure sodium lamp.

3. In the industrial and mining light source part, the light source adopts the flat polycrystalline light source that our company has obtained the US invention patent, the patent number is 200710075903.6. The light source adopts American company chip with high efficiency, low light attenuation and large current margin. The rated current of the chip is 700mA, and the actual use is only 310mA. It has a good heat dissipation design and uses solder for solid crystal bonding. The thermal resistance is small and the operating temperature of the chip is low. The actual junction temperature is less than or equal to 50°C, thus ensuring uninterrupted work and long life.

The LED high-power light source package is imported from the automation equipment of a good company. The solid crystal adopts Taiwan Micro Control Company WEICOM, and the equipment and wire bonding adopt Japanese KIAJO equipment. Ensure the high quality and consistency of the products.

4. About 80% of the energy in the heat dissipation part of the high bay light LED lamp is converted into heat energy. As the power and integration of the LED increases, the heat flux density of the LED fever increases rapidly, and the heat dissipation problem becomes more and more severe. . Excessively high LED junction temperature not only makes the life of the LED sharply attenuated, but also causes severe or even fatal effects on the peak wavelength, optical power, luminous flux and many other functional parameters of the LED. However, the currently used natural convection heat dissipation, fan forced heat dissipation, and various heat pipe heat dissipation methods have very limited cooling capabilities. It has been difficult to obtain heat from the surface of the high-fever LED wick in time and dissipate heat to reduce the temperature to the ideal range. .