1. Remove the dust and dirt on the explosion-proof lamp screen synchronously, and improve the light output and heat dissipation function of the lamp.

Method Clean the water (the lamp is above the mark) or wipe it with a damp cloth according to the lamp used to maintain the housing.

When the water jet is clean, the energy must be blocked. Do not use a dry cloth to clean the plastic (transparent) lamp cover to avoid static electricity.

2. Please note that some bright spots are affected by foreign matters, and the mesh will not be loose, desoldered, corroded, etc.

LED explosion-proof lamp

If this is the case, please stop using and repair on time.

3. Turn off the damage of the lamp in time, and change the notice to prevent the light source from starting, so that the electrical components of the ballast are in an abnormal state for a long time.

4. The lamp chamber used is in a humid environment, for example, the water must be removed in time, and the sealing parts must be replaced to ensure maintenance.

5. When opening the bulb cover, open it and then close the required card.

6. After opening, check whether the explosion-proof gasket is intact, whether the rubber seal ring is thick, if the cable insulation is green and carbonized, whether the insulation parts and electrical parts are deformed, and if you have any questions about the burning fraction, please repair and replace it in time.

7. The wet cloth on the front cover of the closed application silently scrubs the backlight and lamp (not too wet) to improve the lighting power of the lamp.

8. Check whether the transparent parts are damaged by foreign matters, and whether the maintenance network is loose, desoldered or corroded. If yes, please stop using and correct it on time. Recommended reading: excellent high-quality explosion-proof electrodeless lamp

9. If the light source is damaged, the bulb must be turned off in time to inform the replacement of the bulb, so as to prevent electronic components (such as ballast) from being abnormal for a long time because the light source cannot be turned on.

10. When opening the explosion-proof LED lampshade, the power must be turned off according to the requirements of the notice, and then the cover plate must be opened.