Time:2021-11-23 Views:0
LED fluorescent lamps can be divided into three types during installation, one is ceiling embedded, suspended type and direct installation type. However, there are some precautions during installation, such as the following ones.
1. It should be installed in a well-ventilated place with little dust and no corrosive gas, especially inflammable and explosive materials. For example, the lamp is hot, if it is on, it will be banged. The second is the problem of power supply voltage, which can fluctuate in the range of +20% to -20%. If it exceeds that, prepare for failure. The probability of basic damage is very high.
2. Different fluorescent bulbs have special power electronic ballasts. If they cannot be used together, they are also prepared to replace them.
3. The cable connecting the bulb should not be lengthened at will.
4. In places prone to severe cold, you must pay special attention to the sealing effect of the lamp. If you want to maintain the sealing effect, you can disassemble it at will, or you are ready to replace it with a new one.
5. The actual system power deviation of the supporting lamps is within the allowable range within ±10%.
6. There are a lot of people who don’t read the instructions during the installation. In fact, sometimes I don’t understand. If it’s really useless, why do I have a manual for the product? So, I hope everyone will read the manual before installing. , This can reduce the number of replacement of new lamps.
7. Before installing, check whether the lamp is in good condition. Don't wait to press it and find that it turns out to be broken, and then remove it. This is exhausting, so be sure to confirm before installing.
8. When installing, fasten the wide side to one side of the light-emitting mask, and fasten the narrow side to the lampshade.