facebook Twitter Linke in youtube

cap lamps13316809242/15816897019
cap lamps59911926@qq.com/sales@goldenfuturehk.com
explosion proof light

News

Understand industry news

Home >  News>

Three-point selection guide for explosion-proof and anti-corrosion fluorescent lamps

Time:2021-08-12 Views:0

Three-point selection guide, installation and maintenance of explosion-proof and anti-corrosion fluorescent lamps


The explosion-proof and anti-corrosion fluorescent lamp shell is made of reinforced carbonate material, which has the characteristics of high strength, strong impact resistance, high temperature resistance and cold resistance.


Three-point selection guide for explosion-proof and anti-corrosion fluorescent lamps


      1. The light source has been configured when the lamp leaves the factory, and the user can use it when it is connected to the power supply;


      2. When double-tube fluorescent lamps are used for emergency lighting, only one tube will light up;


      3. The conventional supply of boom type installation is the side entry line, if you need to add the line entry, please indicate it when ordering.


Installation and maintenance of explosion-proof and anti-corrosion fluorescent lamps


Only need to open the buckle on the outside of the shell, and the lampshade in large letters can be connected;


The sealing ring of the lead-in device should ensure reliable pressing and clamping of the cable;


Please use plugging plates and compression nuts to reliably seal the unnecessary inlets on the lamps to ensure explosion-proof performance and protection level performance;


Before the lamp is put into use, the internal and external grounding must be firmly and reliably connected to the user's site grounding system;


When installing and maintaining the lamp, it is strictly forbidden to open it with power;


Regularly check the sealing surface, if it is found to be aging, it should be replaced in time;


The emergency battery of the explosion-proof and anti-corrosion fluorescent lamp is in the empty state when it leaves the factory, and the user should fully charge it before using it.