Industrial production lighting involves a wide range of sites and operations, not only in the meticulous production and processing carried out in small and medium-sized production workshops, but also in industrial production and manufacturing in tall and large industrial plants, and in flammable materials and other risky places. For the theme activities of the work, the lighting staff must carry out relative design schemes according to different sites and work characteristics, so as to provide comfortable, economical and safe lighting for the staff.

Harbor Lighting Regulations:

For the lighting of the port, the projection lamp should be installed in the outer field of the boundary, which is convenient for the working area, that is, the area for loading and unloading of goods, so that the lighting effect is not easy to be harmed by obstacles. Such allocations are likely to cause dark shadows to the decks of ships docked ashore when the tide goes out. Therefore, be sure to have flood lighting on the deck and above the jib.

The lighting fixtures on new ships and decks must be able to withstand the natural environment of deep sea salt soil; the raw materials generally used are die-casting aluminum, red copper, stainless steel and other plastics. Also, make sure that the lighting next to the new boat does not easily interfere with the navigation bar signal lights.

Emergency lighting (safety accident lighting) regulations:

Safety accident lighting consideration: Under all normal lighting standards, it can start quickly and perform emergency lighting. The processing plant must be equipped with safety accident lighting equipment and safety evacuation instructions.

Risk area lighting regulations:

The rational layout of industrial plants in refineries and oil tank plants is extremely complicated, not only with key lighting effect obstructions, but also with work surfaces with different aspect ratios.

High-altitude floodlights are installed in many places outside the scope of the risk area, which can provide illumination for safe walking and some document work. In other areas where the system software can not provide sufficient light intensity, some decentralized lighting fixtures must be installed, such as indoor stairs, corridors, gate valves and measurement verification areas.

The installation site of this lighting fixture should be carefully selected to prevent glare when viewed from different horizontal directions. Most of the lighting equipment has a partition frame or a well-shaped door frame, and uses high-pressure or low-pressure gas discharge lamps, which must be consistent with the hazard level of the operation and raw materials in the area.