The venues and operations involved in industrial lighting are very wide. There are both fine processing in small workshops and heavy industrial production in tall factories. According to different places and homework nature, the corresponding design is carried out to provide staff with comfortable, economic and safe lighting.

    Port lighting requirements

For the lighting of the pier, the light cast lamp should be installed at the outside of the border so that the light is not affected by obstacles in the working area, that is, the place where the loading and unloading is loaded. This arrangement may cause shadow to the deck of the shipping ships on the shore. Therefore, be sure to have pan -light lighting on the deck and the lifting arm.

   The lamps on the dock and deck must be able to resist the marine saline and alkali environment; the commonly selected materials are die casting aluminum, brass, stainless steel and other plastic. In addition, the lighting on the side of the dock will not interfere with the navigation signal light.

Factory lighting requirements

Industrial lighting should ensure the comfort and safety of workers when reaching a certain degree of illumination, and reasonable lighting makes the lighting level of the entire ground area and working surface be balanced.

Dangerous area lighting requirements

The layout of the refinery and oil tank factories is extremely complicated, with both the main light obstacles and the working surface of different heights.

The highlights at the high place are installed in several locations outside the dangerous area, which can provide lighting for safety walking and some piece counting work. In this system, it is not yet available to provide sufficient illuminance. It is necessary to install some decentralized local lighting fixtures, such as stairs, aisles, valves and metering areas.

The installation position of these lamps should be carefully selected to avoid glare occur from different levels of directions. Most local lighting equipment has a frame or well -shaped glass frame, which uses high -voltage or low -pressure gas discharge lights, and needs to be compatible with the danger levels of operations and materials in the region.

   Cargo loading and unloading area and stacking field lighting requirements

These areas are mostly used in the storage and transfer of containers or other large goods, so light obstacles have once again become a major design problem. Because most obstacles are moving, fixed local lighting equipment cannot be used.

In addition, it is necessary to consider the movement of cargo trucks, forklifts, lift arms and Longmen's heavy racks. The pan -light installed on high rods, high towers or construction sites can provide general lighting for the locomotives on the rail, transportation on the road, and the safety actions of the staff, and provides local lighting for the shipping goods. The shot light on the top is completed. Because there will be vibration in these positions, the gas discharge lights with better seismic performance are more applicable, but it must be noted that the fluctuation range of the control voltage cannot exceed the standard of the lamp, otherwise the lamps will be extremely easy to break.