Time:2021-09-22 Views:0
1. Before the LED tri-proof lamp is installed, the lamp and its accessories should be complete, and there should be no defects such as mechanical damage, deformation, paint peeling, and lampshade cracking.
2. According to the installation place and purpose of the lamp, the small cross-section of the wire core leading to each lamp should comply with the relevant regulations.
3. When installing electrical lighting devices in masonry structures, they should be fixed with pre-embedded hooks, bolts, screws, expansion bolts, nylon plugs or plastic plugs; wooden wedges are strictly prohibited. When the design is not specified, the carrying capacity of the above-mentioned fixing parts should match the weight of the electric lighting device.
4. In places with greater danger and special danger, when the height of the lamp is less than 2.4 meters from the ground, lighting lamps with a rated voltage of 36 volts and below should be used or protective measures should be taken. Lamps should not be directly installed on combustible objects; when the high temperature part of the lamp surface is close to combustibles, heat insulation and heat dissipation measures should be taken. In the substation, lamps should not be installed directly above the high-voltage and low-voltage power distribution equipment and bus bars. For outdoor lighting fixtures, the height from the ground should not be less than 3 meters; when installed on the wall, the height from the ground should not be less than 2.5 meters.
1. LED environmental protection: There is no ultraviolet and infrared in the LED spectrum, low heat and no flicker, no flicker can protect eyesight, and the waste can be recycled, no pollution, no mercury and other harmful elements, safe contact, real green lighting light source.
2. The life span of the LED tri-proof lamp is very long. Generally speaking, the LED light source is called the tortoise lamp. There will be no loose parts in the lamp body, so there is no phenomenon that the filament emits heat and is easy to burn. Therefore, the service life of the LED tri-proof lamp can reach 50,000 to 100,000 hours, which is more than ten times longer than that of traditional light sources. Greatly reduce the cost of replacement and protection.
3. The LED tri-proof lamp is very energy-saving. It is attributed to the DC drive and consumes very low power. Under the same lighting effect, the LED tri-proof lamp is at least 80% energy-saving than the traditional light source.
LED tri-proof light generally refers to waterproof, moisture-proof and dust-proof. The waterproof protection grade is IP65.
The product light source of LED industrial and mining factory is LED lamp, which can achieve very good energy saving, environmental protection and strong brightness effect, and then replace the tri-proof lamp with fluorescent lamp as the light source on the market.
The mask of the lamp is made of impact-resistant, good-resistant engineering plastic PC, which has a long service life. ABS engineering plastic selected for the bottom cover. The lighting design is waterproof and dustproof, and it is made of novel buckle design and special materials. The bottom cover is equipped with a sealing tape, which is waterproof, dust and insects can enter. Beautiful and well-used, disassembled and flexible, ceiling-mounted equipment.
The scale of use is more suitable for precision machinery processing plants, powder chalk warehouses, parking lots, tunnels, hospitals, pedestrian aisles, textile factories, pharmaceutical plants, brewing plants, food plants, precision machinery processing plants, etc.